Technical Specifications

Video

Bandwidth

10Hz to 200MHz per channel

Formats

RGB computer video formats: RGBHV (VGA), RGBS, RGsB (SoG), RsGsBs (SGI)
Optional SDTV/HDTV analog component video formats: YPbPr with bi-level sync, YPbPr with tri-level sync (480i/p, 576i/p, 720p, 1080i w/o Macrovision)

Sync Configurations

Separate H & V sync, composite sync, sync on green, sync on all 3 colors (red, green, blue)

Sync Signal

Digital TTL sync on separate lines or analog sync added to green or all 3 (red, green, blue) video

Video Signal

0.7Vpp, analog (R, G, B channels)

I/O Impedance

75 Ohms

I/O Sync Level

Separate digital sync lines: TTL, or analog added to video: 0.3Vpp

H Sync Range

15.5 kHz - 160 kHz

V Sync Range

20Hz - 200 Hz

Connectors

VGA IN (Transmitter): high density 15 contact female D-sub
VGA LOOP OUT (Transmitter): high density 15 contact female D-sub
VGA OUT (Receiver): high density 15 contact female D-sub
Non VGA signals connect with BNCs using a 6' BNC to VGA cable

Optical

Modulation

Intensity modulation, analog

Source

3 LEDs

Detector

3 PIN photodiodes

Optical Loss Budget

    dB

Wavelength

820 nm

Connector Type

FIBER OUT R, G, B (Transmitter): 3 ST connectors
FIBER IN R, G, B (Receiver): 3 ST connectors

Fiber Cable

Multimode, 3 strands, 62.5um/125um or 50um/125um, terminated with ST connectors

Power

Power Supply

Internal

Line Voltage

115VAC 60Hz or 230VAC 50Hz, selectable

Front Panel Status Indicators

H SYNC

H sync present (Transmitter): red = signal not available, green = signal is present
H sync polarity (Receiver): red = - polarity, green = + polarity

V SYNC

V sync present (Transmitter): red = signal not available, green = signal is present
V sync polarity (Receiver): red = - polarity, green = + polarity

OPTICAL

green = OK, red = no optical signal or it is too low

POWER

green = on, no light = off

Rear Panel DIP Switch

Switch Position

Selects video format, lever down indicates selected (only one lever can be down)

1

RGBHV (VGA)

2

RGBS

3

RGsB (SoG)

5

YPbPr/bi-S    (with bi-level sync)

6

YPbPr/tri-S    (with tri-level sync)

Selects sync polarity (Receiver only), lever down is - polarity and up is + polarity

7

HS/CS POL    (H or composite sync polarity)

8

VS POL    (V sync polarity)

General

Width (W)

16.3in / 414mm

Depth (D)

10in / 254mm

Height (H)

1.625in / 41.3mm (with rubber feet unit sits 0.12in (3.1mm) higher)

Weight

Transmitter: 4.4lbs / 2kg
Receiver: 4.4lbs / 2kg

Enclosure

• 1 unit height (1U)
• full 19” rack wide
• aluminum
• top and bottom black powder coated, medium textured
• front and rear light gray powder coated, lightly textured finish with black silk screening
• 19” rack mountable with mounting ear kit, or stand alone